By Mark J. Donovan
|
|
Cracked house siding is a one way ticket for water damaged to
your home if left unchecked. It is important to replace cracked
house siding as soon as it is observed, to prevent water from
seeping in behind the house siding and causing mold, mildew and
rot to the sheathing and framing. |
|
Consequently I found myself frequently replacing cracked house siding. From this experience I learned a few things about how to prevent and replace cracked house siding.
How to Prevent Cracked House Siding
|
Photo By: Mark Donovan |
|
|
First, the house siding should be painted or sealed on all six sides of a clapboard. This helps to stabilize the wood as it is completely sealed from moisture, and thus can not swell and contract due to moisture and humidity levels. It is this swelling and contracting that is one of the main reasons for cracked house siding clapboards.
The second major tip on how to prevent cracked house siding is to nail it properly to the house sheathing. When installing overlapping house siding clapboards, only one horizontal row of nails should be ideally installed into each clapboard piece.
|
The nails should be placed such that they only penetrate through the piece of clapboard that is being nailed up. They should not penetrate through the clapboard that it is overlapping.
For example, if you are overlapping the clapboards by 1.25 inches, the nail should be installed into the top clapboard 1 and 3/8ths inch above the bottom edge of the top house siding clapboard. This nailing technique will allow the house siding clapboard to expand and contract more readily due to changes in temperature. As a result, you should minimize the risk of cracked house siding.
Replacing Cracked House Siding
Replacing cracked house siding is a project that most DIY
homeowners can perform as long as they own a few basic carpentry
tools.
Replacing cracked house siding is relatively easy to do, however
it can be a little tricky removing the cracked house siding
while leaving the remaining clapboards in place and undamaged.
|
To replace a cracked house siding clapboard, begin by carefully cutting the damaged clapboard over a wall stud that is located well beyond the cracked area. Do this by marking the location first with a pencil, and then using a utility knife to repeatedly score the cracked house siding clapboard. |
Photo By: Mark Donovan |
This process will create a relief line which will help to ensure the cracked house siding breaks along this vertical line when you go to remove it later.
Next use a pry bar to carefully lift up and away from the
sheathing the good house siding clapboard that sits above the
cracked clapboard. Continue to carefully work the pry bar
underneath the good house siding piece to help lift the nails a
little. This will create room to slide out the cracked house
siding clapboard.
Next, work the pry bar up and underneath the bottom section of
the cracked house siding clapboard, making sure not to damage
the good one that sits below it. Use a small block of wood for
leverage and to protect the lower house siding clapboard.
Once you have slightly lifted the cracked house siding clapboard
away from the house sheathing use a hammer to remove the nails
from it. You can also use a reciprocating saw to cut the nails
on the backside of it if necessary.
After removing the nails, pull the cracked house siding
clapboard off of the house, being careful not to damage the
other siding pieces in the process.
Install New House Siding Patch
First, check to make sure there is a housing wrap (e.g. Tyvek)
behind the area where the cracked house siding existed. There
should be one if the house siding was installed correctly. If
there is not you should seriously consider installing a housing
wrap around the entire house, if and when you ever decide to
reside the entire house. The housing wrap is a secondary barrier
to the natural elements such as water and wind and should be
used on every home construction project.
If there is housing wrap already on the sheathing, use some duct
tape to patch up over any tears that may have occurred during
the removal of the cracked house siding clapboard.
Also, after removing the cracked house siding piece, make sure
there are no nail stubs protruding behind the upper house siding
clapboard, as you will be sliding the new house siding clapboard
up underneath it. If there are cut nail stubs protruding out
from behind the upper clapboard, use your pry bar and hammer to
flatten the nails flush with the house sheathing.
Also remove any cut nail stubs associated with the cracked house
siding clapboard that was removed.
Next, measure and cut a piece of new house siding.
Prime the new house siding piece on all six sides and put a bead
of caulk along the vertical edges of the existing house siding
clapboards that will butt up to the new replacement clapboard.
Next, slide the new house siding clapboard up underneath the
existing house siding clapboard.
After positioning the new clapboard into place, nail it to the
house with hot tipped galvanized nails or stainless steel nails.
You will preferably want to use 8D nails so that they penetrate
approximately 1.5 inches into the framing studs.
Finally touch up the replaced cracked house siding clapboard
with a coat of paint and you’re finished.
Patching Wood Siding Ebook - If you require more detailed instructions, and additional pictures for patching wood siding see HomeAdditionPlus.com's Patching Wood Siding Ebook. This Ebook provides very detailed instructions, along with pictures for each key step in the process of patching wood siding.
How to Finance your Home Siding Project - can help provide funds for your new home improvement project if financing is required.
Related Home Siding Information
