Home Addition Plus

Helping Homeowners Every Day

 
    Home How-To Store Ebooks    Bid Sheets HouseSight About Us Contact

 

 
 

    

 

                             

Home Addition Bid Sheet 

 

Home Improvement Tools from Amazon

 

Visit My

Amazon

Tool Store

 

                           

 

 

   

 

Ez-Hang Door Installation Brackets make Interior Pre-Hung Door Installation a Snap

An Ingenious Way to Quickly Install Interior Prehung Doors

By Mark J. Donovan

I recently received a neat interior door installation kit that makes installing interior prehung doors a snap. The kit is from Innovative Construction Enterprises and is referred to as the “EZ-Hang Door Installation Bracket Kit”. See EZHangDoor to learn more.

When installing an interior prehung door it is important to make sure the door is plumb and square in the door frame. If it is not, the interior door may not open and close properly and/or you may see wide and uneven gaps between the door edge and door jamb.

 

Normally the process of making sure the door is plumb and square within the doorframe is a repetitive process involving the use of a level. As you continue to fasten the interior prehung door to the rough door frame you repeatedly have to keep checking with the level to see if the door is still plumb and square. The “EZ Hang Door Installation Bracket Kit” helps eliminate the repeated steps with the level.

With the “EZ Hang Door Installation Bracket Kit” you start out by simply using a 4 or 6 foot level and marking a straight and plumb pencil line along the hinge side edge of the door opening. The mark should be approximately ˝ inch in from the door opening edge, and on the drywall surface.

After making the plumb line, you then fasten the EZ-Hang door brackets to the interior prehung door frame. Make sure not to remove the door latch plug when installing the door.

 

On the hinge side of the interior prehung doorframe you apply one EZ Hang Door bracket just below each hinge and flush with the edge of the door frame. On the knob side of the door frame, you install one EZ-Hang door bracket 12 inches down from the top of the doorframe, another 2 inches above the latch hole, and another 6-8 inches up from the bottom. For doors wider than 30 inches, it is also recommended to install a 7th bracket centered on top of the door frame.

 

With all the EZ-Hang door brackets installed on the door frame, you next slide the interior prehung door/doorframe into the door opening and align the hinge side EZ-Hang door brackets with the plumb line marked on the wall. There are a couple of reference lines on the EZ-Hang door brackets to help in properly aligning the door brackets with the plumb line mark.

 

Once you have the EZ-Hang door brackets reasonably aligned along the plumb line, start at the top hinge side bracket and secure it to the wall surface using the drywall screws that come with the kit. The drywall screws will penetrate through the drywall and into the wall studs.

Continue to work your way down the hinge side of the door, fastening the remaining EZ-hang door brackets to the drywall surface.

Next, make sure the spacing on the door knob side and top of the door frame are even and continue to secure the EZ-Hang door brackets to the drywall.

Once you have installed the interior door to the door opening, you can then install some shims behind the hinge plates and near the door knob latch plate to stiffen up the doorframe.

Installation of interior door using EZ-Hang door installation brackets.

Courtesy of EZHangDoor.com

 

Use a finish nail along the inside door jamb to hold each set of shims in place.
 

Finally you can trim out the door with door moulding. The door moulding goes directly over the EZ-Hang door bracket tabs that are fastened to the drywall.

The interior door installation process is significantly reduced by using the “EZ-Hang door bracket Kit”, and more importantly, your door will be sure to work properly when opening and closing it.

The cost of an “EZ-Hang Door Bracket Kit” is just a few dollars and it is well worth the investment. If you have interior door installation plans make sure to pick up couple of these kits when purchasing your doors.

 

DIY HomeAdditionPlus.com Disclosure Policy Statement

 

Find a Qualified Home Remodeling Contractor in Your Area

Get Free Quotes.  Easy, Quick and No Obligations!

 

For the home improvement or home remodeling project that is too big for you, check out our partner NeedContractor. They are a national resource for finding pre-screened, insured, and licensed home improvement and remodeling contractors in your local area.

Find Local, Pre-Screened Contractor for Building a Small Home or Green Home

 

Get Matched in 48 hours with Home Remodeling Contractors!

 

For information on Installing Interior Door Trim, see the Installing Interior Door Trim Ebook from HomeAdditionPlus.com.  The Installing Interior Door Trim Ebook provides easy to understand, step-by-step instructions, on how to install interior door trim around an interior or exterior door. Pictures are included for every key step in the process.

 

 

 


Finish Carpentry Tools from Amazon.com

 

         

 


Get Free Door Price Quotes, No Obligation!

Fill out our 3-5 minute quick and easy form, and receive a free price quote on interior door installation from one of our prescreened and licensed door contractors. This process is free and there is no obligation to continue once you receive your door replacement price estimate.

  
     

- Ez-Hang Door Installation Brackets make Interior Pre-Hung Door Installation a Snap -

[Back to Product and Material Reviews]

 

 

 

 
     

Follow HomeAdditionPlus on Twitter

to HomeAdditionPlusVideos / Subscribe to HomeAdditionPlus.com feed

Advertise / Favorite Links / SiteMap / ToS / Privacy Policy / Disclosure Policy

Copyright 2005-2012 by DIY HomeAddition Plus.com - A Do it Yourself Home Improvement Site

 

web metrics