|
|
|
How to Vent a Dryer
Venting a Dryer is Key for
Drying Clothes and Preventing House Fires
By Mark
J. Donovan
|
|
It’s important to vent a dryer if you
want the dryer to actually dry your clothes. It’s also just as important to vent
a dryer to prevent your dryer from causing a house fire. Moreover it’s just as
important to clean the dryer vent periodically to remove any lint buildup in it.
Every year thousands of homes catch fire due to dryer’s being improperly vented
or the dryer vent being clogged. Installing a dryer vent, and keeping it clean,
is very easy to do. With a few basic tools and a little self discipline you can
install your own dryer vent and keep it clean and operating safely.
|
To install a dryer vent, find the
most direct route from the dryer to an exterior wall where you want to vent the
dryer. Make sure that there are as few turns as possible. Remember each turn
is an eventual choke point in the dryer ductwork. In addition more turns
complicate the dryer vent installation. Mark the location for the dryer vent
with a pencil on the interior and the exterior side of the wall. This way you
can confirm that it will be located where you truly want it on the outside of
your home.
Next purchase the necessary galvanized steel ductwork, including straight and
elbow pieces. Make sure you also purchase sheet metal screws specifically
designed for fastening the ductwork together. Also purchase the dryer vent. Make
sure the dryer vent includes a cap to keep the insects and critters out.
Use the dryer vent cap assembly as a template for marking the opening on the
exterior of the home. Then use a drill and a large 1 inch drill bit to create
several pilot holes around the circumference of the marked circle. Next use a
jig saw to cut out the opening for the dryer vent. Alternatively you can use an
appropriately sized bimetal hole saw to cut out the opening. Take your time
cutting out the hole as you may go through a nail or two in the process.
|
|
After cutting out the opening install
the dryer vent cap assembly into the opening and fasten it to the exterior of
the home with the screws provided. Finally caulk around the dryer vent to ensure
an air tight seal. Make sure to caulk on both the outside and inside of the
dryer vent assembly.
Next, cut and assemble sections of ductwork as necessary to connect the dryer’s
vent opening with the dryer vent cap tubing penetrating into the home. Make sure
to connect the pieces of ductwork together with sheet metal screws.
|
Also apply metal foil tape around all of the seams. Tin snips work best for
cutting ductwork. Make sure to wear gloves and eye protection when working
with ductwork. Attaching the final section of ductwork to the dryer can be a
challenge as you are inevitably working in tight quarters. Make sure to
measure the final section of ductwork based upon the final location of the
dryer.
Once you’ve installed all of the ductwork and have positioned the dryer in its
final resting place plug it in and test the dryer. Go outside the home and
make sure that the dyer vent cap is open and that warm air is exiting it. Once
or twice a year make sure to clean the dryer vent. Use a vacuum cleaner with a
long hose to clean as much of the duct work as possible. Also make sure to
clean both the dryer side and the exterior vent cap side.
Related Articles
Dryer Vents from
Amazon.com
|
|
|
