|
|
|
How to Use a Spring Mouse Trap
The Old Fashioned Basic
Mouse Trap is Still one of the Best Mouse Traps for Catching Mice
By Mark
J. Donovan
|
|
Every once in a while I get mice in
my home and am forced to set up spring mouse traps. I typically find my home
susceptible to mice infestation in the late fall, when I accidentally leave my
garage doors open. Mice are looking for warm places to hold up for the winter
and a garage or basement is a perfect place for them to set up camp. Though
spring mouse traps are lethal to the mice, I find them to be extremely
effective. Mouse glue traps also work well, but for some reason I have more of a
problem knowing a mouse is simply going to sit in one place for a lengthy period
of time and suffer until they die of thirst and hunger.
|
I find spring loaded mouse traps work best if you set them up in the late
afternoon due to the fact that mice are nocturnal. This way I don’t have to
leave the mouse traps armed and dangerous for too long of a period of time. By
morning I usually have my captured mouse or mice. I also typically set 3 or 4
mouse traps at a time to increase my probability of eliminating the mice
infestation problem.
When setting a basic spring mouse trap with a snap bar it is important to take
some safety precautions and care. I personally wear work gloves when setting
them to lessen the pain if I accidentally trigger one after setting it.
|
|
To set a spring mouse trap first
remove the staple that holds the long metal pin, or locking bar. The locking bar
is effectively used to hold the spring loaded snap bar in its set and loaded
position, and attaches to the bait plate pedal.
Next, add bait such as peanut butter or cheese to the top of the bait plate
pedal.
I find it best to set the mouse trap in the immediate area where I want to
locate it.
|
In addition, I often tie string to it and attach the other end to a fixed
object. This way I don’t have to hunt around for the missing mouse trap in the
morning. Often after a mouse gets captured in one of these types of mouse traps
they can roam a bit from the area before they expire. Sometimes finding the
trapped mouse can be difficult.
| After loading the trap with bait, pull the mouse trap’s snap
bar back and hold it tightly in place with your thumb. With your other hand
place the locking bar over the snap bar and hook it to the base of the bait
plate pedal. Typically there is a small tongue or “U” shaped hook that
attaches to the bait plate pedal. Be very careful in doing this so the trap
does not spring on you. Once the trap is loaded, very gently and carefully
set it into place near the target location. |
Photo by Mark Donovan |
For best results, I find putting it in a corner near a wall works the best.
Position the trap so the bait plate pedal sits nearest the wall.
In the morning check the trap. If it is set, again put on the work gloves to
release and dispose of the dead mouse. Reset the trap again in the evening if
you think you still have a mouse problem.
Related Articles
Related Topics on
Mouse Traps
Rat and Mouse Traps from Amazon.com
|
|
|
