How to
Install Lattice around a Deck Video
Useful Tips on How to Install Lattice around a Deck
By Mark J. Donovan
|
In this video Mark Donovan of HomeAdditionPlus.com shows how to install
lattice around a deck.
When replacing old and damaged lattice around a deck, try to save the old
lattice pieces as templates for cutting out the new lattice material.
In this video I am using 4'x8' sheets of pressure treated lattice. I am
using the thicker 1/4" lattice so that the deck lattice will standup to the
more harsh environment of the lower portion of a deck. I highly recommend
not using plastic lattice around the bottom of a deck.
|
Lattice Products from Amazon.com
|
Plastic lattice is very susceptible to cracking and breakage, and should
therefore be limited to applications where it can't be easily banged, e.g. by a
lawnmower in this type of application.
After cutting each lattice panel I temporarily fastened them to the side of the
deck with one or two exterior grade deck screws to make sure all the panels
lined up properly. I then removed them and stained the lattice on the ground.
I stained the lattice using a brush and a transparent decking stain. Staining
lattice with a brush is a slow and tedious job, however I find by applying the
stain by hand that is holds up better.
After staining the lattice panels and allowing them to sufficiently dry, I
permanently installed the lattice using deck screws. I used some additional lumber on the outside
corner to dress the corner up a bit.
For help on building a new Deck, see HomeAdditionPlus.com's
Deck Installation Bid Sheet.
The
Deck Installation Bid Sheet
will teach your how to hire the right deck contractor, and help to ensure that your
deck project is completed on time and budget.
Deck Building and
Deck Maintenance
Videos
|
